Volvo RWD 140-160 Forum

INDEX FOR 1/2026(CURRENT) INDEX FOR 4/2005 140-160 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE    PRINT   SAVE 

Any front cam bearing problems? 140-160

posted by  blackjackmc on  Mon Nov 7 15:42 CST 2005
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS]
last visit: Mon Jul 27 10:24 CST 2009
[RELATED]

My 74 8 bolt 120e had 7100km genuine one owner and untouched mechanically. No1 tappets were always very noisy,if i adjusted them it would miss bad until i opened them up again. Pulled engine and found exact same wear as you describe, plenty metal in sump so would not think it melted. Oil ways were aligned and cam lobes had moderate wear. My conclusion was swarf from cam lobes and lifters chewed out front brg because of extra thrust of timing gear. Regards to all, 2 months into full time motorhome lifestyle and loving it, big place this Oz.






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New Any front cam bearing problems? [140-160]
posted by  uniberp  on Mon Nov 7 07:12 CST 2005 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.