Volvo RWD 140-160 Forum

INDEX FOR 1/2026(CURRENT) INDEX FOR 5/2003 140-160 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE    PRINT   SAVE 

Steering/brakes problem 140-160 1972

posted by  someone claiming to be belinda on  Sat Dec 24 10:50 CST 2005 [RELATED]

I'm curious about 164 front brake calipers.. I have a PV444 and am upgrading to disk brakes and I heard that 164 calipers may be thicker (than say 1800/122 calipers) and that they may be thick enough to accept 7/8 - 1" thick vented rotors. Is this true?

As far as your problem, yup, I'd agree that the ball joints in the tie rods & ends are likely shot. I just went through my entire front end and replaced everything that needed it and it was pretty much everything including these as well as bushings, rebuilding the idler arm, and all the control arms. My car was so bad that when I stepped on the brakes at high speeds the car would jump into the next lane (to the right). It was scary taking things apart, realizing I had been driving on those ball joints. Completely swimmy. Not very safe at all.






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New Steering/brakes problem [140-160][1972]
posted by  jdr5q  on Fri Dec 23 09:51 CST 2005 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.