Volvo RWD 200 Forum

INDEX FOR 1/2026(CURRENT) INDEX FOR 10/2006 200 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE    PRINT   SAVE 

crank sensor replacement...... hints!!!!! 200

posted by  Art Benstein on  Wed Sep 20 12:35 CST 2006
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS]
last visit: Fri Oct 17 20:10 CST 2014
[RELATED]

Hi,

I like all the advice. This little bugger must be quite a challenge sometimes.

So far I've been fortunate, not to have one frozen solid in place. I reach with my left hand under the heater pipe and use a stubby box wrench. I'd try a gear wrench if I had one, but I suspect after first breaking the bolt loose, it would not be tight enough to operate the ratchet, and there is definitely room for only one hand in there. Just did this again last weekend.

It is true you can't see and do it at the same time, so get a good look first. Maybe you've seen the pictures of all the room in the 740, but here's what it looks like in your model.






--
Art Benstein near Baltimore

"I was worried that my mechanic might try to rip me off, I was relieved when he told me all I needed was turn-signal fluid."






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New crank sensor replacement...... hints!!!!! [200]
posted by  trichard  on Wed Sep 20 05:18 CST 2006 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.