Volvo RWD 200 Forum

INDEX FOR 1/2026(CURRENT) INDEX FOR 6/2006 200 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE    PRINT   SAVE 

What Bentley error? 200 1991

posted by  scorron on  Sun Feb 11 03:02 CST 2007
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS]
last visit: Tue Oct 7 21:10 CST 2014
[RELATED]

One section of the book says to measure resistance between terminal 13 and ground to test coolant temp sensor, and another section of the book says to measure resistance between terminal 2 and ground. I'll assume the coolant temp sensor is connected to both then, and the only reason to check at different terminals would be to test that the signal is reaching both systems properly.

If there is no error there, then apparently I was not incorrect in telling Vin to use terminal 2, because they both must connect to that sensor. Since Vin was trying to test the sensor's function itself rather than whether or not the respective computer systems get the signal, I suppose either terminal will work.
--
Sean - now frolicking in the Land of a Thousand 240's (aka, Fredericksburg) thrice a week.






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New Anyone has the J-tronic Fuel injection manu: checking temperature sensor [200][1991]
posted by  Vin  on Tue Feb 6 18:20 CST 2007 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.