Volvo RWD 200 Forum

INDEX FOR 1/2026(CURRENT) INDEX FOR 12/2010 200 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE    PRINT   SAVE 

Caveat when using small flat screwdriver to pull seals. 200

posted by  B.C. on  Mon Oct 1 13:18 CST 2007
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS]
last visit: Wed Mar 28 22:28 CST 2012
[RELATED]

I was both fortunate and un-fortunate last time I did this job.

Bad luck - put a tiny scratch on the intermediate shaft when the screwdriver tip slipped. Rats! I knew a tiny scratch would leak.

Good luck - I had on hand the 400 grit emery paper to smooth out the shaft enough to remove the scratch. Took 2 hours, though.

I would still use the screwdriver again, with extreme care.

Regards,

Bob

:>)






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New 1 Another timing belt change question [200]
posted by  Mark's 240  on Mon Oct 1 02:42 CST 2007 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.