Volvo RWD 200 Forum

INDEX FOR 1/2026(CURRENT) INDEX FOR 2/2010 200 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE    PRINT   SAVE 

This is getting way too complex. 200 1992

posted by  dash on  Sat Nov 24 08:24 CST 2007
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS]
last visit: Sat Jul 19 08:01 CST 2008
[RELATED]

OK.

1) I think I changed the switch without having to because when I set the meter to OHMS I get no reading when pushing the switch button in and a 0.00 reading when I release the button (brake engaged).

2) I did get a 12 volt reading at the blue/black wire socket so it's OK.

3) I did not get a voltage reading at the yellow wire.

4) I do not have a yellow/gray or blue/black wire but I do have a yellow/blue but I guess it doesn't matter, right.

Maybe I can try to resolder the joints on the circuit board and get lucky. Or can the sensor fail even if the solder joints are good?





THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New Brake lights quit working [200]
posted by  dash  on Thu Nov 22 13:05 CST 2007 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.