Volvo RWD 120-130 Forum

INDEX FOR 1/2026(CURRENT) INDEX FOR 10/2000 120-130 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE    PRINT   SAVE 

Replacing a B-18 with a B-20 120-130 1966

posted by  Ron Kwas on  Sat Feb 9 01:09 CST 2008
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS]
last visit: Fri Oct 24 04:03 CST 2014
[RELATED]

Dylan;

There's not that much different which will be a showstopper...the generator bracket mounting holes are there to accept your generator, although when in service, the B20FI probably had an Alt pivoting in the single big hole (so chase out the three mounting holes before inserting bolts)...the injector holes need to be blocked because you wont be supplying fuel there, and you certainly dont want to leave them open...it would make it difficult to adjust your idle!
(see also: http://www.sw-em.com/service%20notes.htm#Engine ), and you'll want to get with the engine the additional cast support bracket (12)
as I said...no showstoppers in sight (did I forget anything?)!

Cheers






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New Replacing a B-18 with a B-20 [120-130][1966]
posted by  Dylan Berichon  on Sat Feb 9 00:02 CST 2008 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.