Volvo RWD 700 Forum

INDEX FOR 1/2026(CURRENT) INDEX FOR 7/2004 700 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE Replies to this message will be emailed.    PRINT   SAVE 

Changed out a crank sensor with one wrench 700 1991

posted by  Andrew in AL on  Mon Jun 30 09:25 CST 2008
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS]
last visit: Fri Oct 24 06:17 CST 2014
[RELATED]

Absolutely. Smooth as a babies butt, actually.

The inability to easily hold a good idle and what seemed to be something akin to backfiring when I did throttle up and let off the gas ..I think, can be laid at the feet of a ridiculously maimed crank sensor lead.

Now I have to go back and remove it and reset it, after cleaning properly with some brake cleaner, not brake fluid :(.

I did mean to ask if there was a suggestion on something to lube or coat the area with, like WD40 - after I clean it. Just was not sure if the area below would be OK with something like WD40.

Thanks for checking back.
--
' Of all bad men religious bad men are the worst. '' (C S Lewis






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New Changed out a crank sensor with one wrench [700][1991]
posted by  Andrew in AL subscriber  on Sat Jun 28 07:40 CST 2008 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.