Volvo RWD 200 Forum

INDEX FOR 1/2026(CURRENT) INDEX FOR 7/2004 200 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE Replies to this message will be emailed.    PRINT   SAVE 

Starting problem 200 1980

uid 18083's pic
posted by  lucid on  Mon Aug 4 08:35 CST 2008
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS]
last visit: Fri Oct 24 12:31 CST 2014
[RELATED]

"If I connect #9 (hazard) to #7 (main fuel pump) should it turn on?"

No, it should have run when you had voltage* applied to #5, ideally to the #5 input terminal (left side contact), which is where the fuel relay sends it.
From there it goes 2 ways:

1) Directly to the Main pump (via a connector under the rear seat, left side)
and
2) Through fuse #5 to the Tank pump.

Fuse 7 (always hot) passes voltage to the Fuel relay input. When energized, the relay passes the voltage on ("relays" it) from its output terminal(s).

* When getting jumper voltage from a live fuse terminal (from any one of always hot 6—10) I work from the left side (input) contact rather than the right (output) side. This eliminates misleading glitches from a possibly faulty fuse or fuse contact.






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New Starting problem [200][1980]
posted by  sfraser  on Sun Aug 3 07:25 CST 2008 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.