Volvo RWD 120-130 Forum

INDEX FOR 1/2026(CURRENT) INDEX FOR 5/2008 120-130 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE Replies to this message will be emailed.    PRINT   SAVE 

subframe dimensions 120-130

posted by  walrus3 on  Sat Sep 13 03:39 CST 2008
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS]
last visit: Mon Dec 2 14:20 CST 2013
[RELATED]

Upper control arm pivot? Upper A-frame shaft? I think I am getting a glimmer
now. Yes those are 7/16"-14 UNC. Sorry for my density. Those are pretty critical
bolts because they also hold the alignment shims and may be subject to eccentric tension
loading depending on the shims required.
If you want to go oversize you could put M12-1.75 bolts in there probably with no more than
running a tap into the hole. The threads are VERY close and the size differs by 0.037".
You would be less than half a thread off at a 1" depth. That would probably be filled by
the difference in diameter in the threaded length of that hole.
--
George Downs, Bartlesville, Heart of the USA!






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New subframe dimensions [120-130]
posted by  luten  on Fri Sep 12 00:26 CST 2008 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.