Volvo RWD 1800 Forum

INDEX FOR 10/2025(CURRENT) INDEX FOR 5/2022 1800 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE    PRINT   SAVE 

Injector Trigger Ohms Test 1800 1971

posted by  RepairmanJackal on  Sun Oct 12 11:34 CST 2008
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS]
last visit: Tue Jun 10 09:52 CST 2014
[RELATED]

I pulled the dizzy and brought it inside to my desk for a check with the digital multimeter.

With manual counter-clockwise rotation and a digital meter set to the 200 ohms range, the center pin to the "left" pin (the one closer to the condenser) returns 0.6-0.7 ohms before continuity is lost. The center pin to the "right" pin (the one closer to the vacuum mechanism) returns 1.0-1.1 ohms before contact is lost. I get that normal "alternating" 360 degree reading as described in the VClassics article on Druck-Jet.

I'm a little bothered that the resistance for the left set is about half of the right set, but unless you guys suggest otherwise, I'm not going to mess with bending the contacts for a measly 0.4 ohms. That may adjust out if I loosen the screws and wiggle a bit.

Clearly they are "breaking" so I'm at a loss to explain why my injectors are no longer firing.

The Fault tracing manual does not seems to suggest much here aside from "Replace Injectors"






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New Points File, D-Jet Trigger Points [1800]
posted by  RepairmanJackal subscriber  on Sat Oct 11 04:59 CST 2008 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.