Volvo RWD 120-130 Forum

INDEX FOR 1/2026(CURRENT) INDEX FOR 11/2012 120-130 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE    PRINT   SAVE 

Engine and tranny mounts 120-130 1967

posted by  KlausC on  Thu Nov 5 15:45 CST 2009
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS]
last visit: Fri Oct 24 10:15 CST 2014
[RELATED]

Thanks George,
I saw the nut sticking up out of the grime, but had a hard time visualizing the other end behind the crooss member.

Gunk? This car doesn't need rust proofing :) With the leaking front crank seal, it tooK quite a while just to clean that. There are some other leaks in the rear which I haven't found yet and when I replace the tranny mount I will clean it all up.
I just hope that my tranny/OD is not leaking. I have never taken one off before and do not look forward to that.

Klaus
--
Proud owner of a 220S. If I had more room, I would have more Volvos.






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New Engine and tranny mounts [120-130][1967]
posted by  KlausC subscriber  on Thu Nov 5 10:09 CST 2009 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.