Volvo RWD 200 Forum

INDEX FOR 1/2026(CURRENT) INDEX FOR 6/2007 200 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE    PRINT   SAVE 

Adding another wire through the gear shift shaft 200 1985

posted by  Jesse B on  Thu Jul 15 03:17 CST 2010
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS]
last visit: Fri Oct 24 11:47 CST 2014
[RELATED]

Does your car have an m46?

I replaced the OD wires in my shifter (kind of a pain).


I found the easiest way was to take the entire shifter mechanism apart. You cannot get the wires through otherwise.

-There is a little screw that holds the piece of plastic that holds the shift knob. Be careful not to lose this when you take that part out.

-Driving out the pin that holds the shift shaft is a pain, but in the long run makes it easier.

-Make sure you also use flexible wire.


Hope this helps.






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New Adding another wire through the gear shift shaft [200][1985]
posted by  Shaughnessy  on Wed Jul 14 13:54 CST 2010 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.