Volvo RWD 700 Forum

INDEX FOR 1/2026(CURRENT) INDEX FOR 11/2002 700 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE Replies to this message will be emailed.    PRINT   SAVE 

CSI code may be due to a wiring change 700 1990

posted by  oldguy on  Mon Feb 14 12:42 CST 2011
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS]
last visit: Mon Sep 1 13:35 CST 2014
[RELATED]

OK Thanks - I will not worry about the error code. But My CSI was not wired to the starter. I probably do not need it in Louisiana anyway.

Any info about te Idle Valve? If the error code is just a old change, I can ignore and just put everything back together.

By the way, when pulling the injector connectors I think I lost a couple of the silicon rubber seals? Is silicon grease for reconnecting on the outside ok, or should I buy some seals or use a little silicon gasket material?






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New Troubleshooting Idle Valve and Cold Start Injector error codes-ECU resistance to ground [700][1990]
posted by  oldguy  on Sun Feb 13 23:01 CST 2011 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.