Volvo RWD 120-130 Forum

INDEX FOR 1/2026(CURRENT) INDEX FOR 2/2011 120-130 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE Replies to this message will be emailed.    PRINT   SAVE 

Disassembling PBR clutch master cylinder? 120-130

posted by  lukeball on  Tue Feb 15 21:23 CST 2011
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS]
last visit: Tue Oct 21 20:12 CST 2014
[RELATED]

What held the plunger in place? Usually, there is a slotted washer that holds the plunger down and a clip on top of it that holds the whole assembly. With the plunger removed, the piston should come out. Push down on the piston with a dowel rod and remove quickly and it should pop out.

I had problems removing the piston on my master cylinder, so I connected the air compressor to the port and blew it out. Watch out though, pressure builds and that piston could hurt you (it put a dent in my front fender.

Hope this helps.
--
1959 Volvo Amazon 121






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New Disassembling PBR clutch master cylinder? [120-130]
posted by  red92s subscriber  on Tue Feb 15 16:12 CST 2011 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.