Volvo RWD 120-130 Forum

INDEX FOR 1/2026(CURRENT) INDEX FOR 2/2012 120-130 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE    PRINT   SAVE 

Disassembling PBR clutch master cylinder? 120-130

posted by  nockenwellenrad on  Wed Feb 16 09:03 CST 2011
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS]
last visit: Mon Nov 11 11:00 CST 2013
[RELATED]

On a lighter note, I used PBR boxes for floor patch templates in my Amazon last winter:
http://olddeadvolvos.wordpress.com/2009/10/12/patch-blue-ribbon/

On a more serious note I haven't had too much luck rebuilding aluminum hydraulic cylinders. They tend to heavily corrode and form deep pits- but that's here in New England.

Best of luck!

Jim
--
'58 PV444
'66 1800S
'67 122S Estate
'70 142S
'72 142E
'78 242GT
All are pretty and run except the '78 The irony!
http://www.olddeadvolvos.com






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New Disassembling PBR clutch master cylinder? [120-130]
posted by  red92s subscriber  on Tue Feb 15 16:12 CST 2011 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.