Volvo RWD 444-544 Forum

INDEX FOR 1/2026(CURRENT) INDEX FOR 3/2002 444-544 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE    PRINT   SAVE 

Lever Arm Length Calculation 444-544

posted by  malloy1 on  Sat Feb 26 19:31 CST 2011
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS]
last visit: Sun Oct 12 17:44 CST 2014
[RELATED]

The question (I guess this is for the physics or math people out there): What is the length of the tab (from pivot point to the hole for the push rod hole)I need? I've calculated the lever arm length (2"), but would like somebody else to confirm it to make sure I did it right. The picture will give you an idea of what the length and angles I used:

Photobucket


The 5.75" is the travel distance of the pedal, and the 9.5" is the length of the pedal. I calculated the angle at the pivot point to be 35*. The travel of the clutch master is 1.25".

Did I miss anything?





THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New Clutch Linkage Setups [444-544]
posted by  malloy1  on Sat Feb 19 20:07 CST 2011 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.