Volvo RWD 700 Forum

INDEX FOR 1/2026(CURRENT) INDEX FOR 5/2007 700 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE Replies to this message will be emailed.    PRINT   SAVE 

Missing connector/wires? 700 1992

uid 18083's pic
posted by  lucid on  Wed May 25 09:33 CST 2011
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS]
last visit: Fri Oct 24 12:31 CST 2014
[RELATED]

"So you installed the pump without the connector by soldering the wires? It worked?"

Yes. At that time (about 5 years ago) that was the standard method, with the pump having "eyelet" type terminals, as in the pic below. I believe I just soldered short leads to the new pump (on the bench). Then used crimp splices to connect them when the pump was fitted in place in the sender.

I don't think I used the black rubber (silencer") sleeve as it seemed too thick to fit the pump into it's sender location.





--
Bruce Young, '93 940-NA (current), 240s (one V8), 140s, 122s, since '63.






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New Fuel Pump Replacement Questions [700][1992]
posted by  Michael Littman  on Tue May 24 14:41 CST 2011 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.