Volvo RWD 120-130 Forum

INDEX FOR 1/2026(CURRENT) INDEX FOR 2/2007 120-130 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE Replies to this message will be emailed.    PRINT   SAVE 

What would cause a bent spark plug tip at the connection? 120-130

posted by  KlausC on  Fri Jul 15 11:33 CST 2011
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS]
last visit: Fri Oct 24 10:15 CST 2014
[RELATED]

You cracked the tip while installing it, because the socket slipped. After putting the cap on, the crack enlarged and the tip was pulled lightly by the plug wire.

As the others have mentioned, get a better socket with a rubber insert. Not only will this prevent the problem, the rubber insert will catch the plug so that it doesn't fall down to the ground and break.

Torque? Hand thread the plug until it seats, then use the socket to snug it up. 25lbs isn't much. Put a thin layer of anti-sieze on the thread of new plugs to make extraction easier.

Klaus
--
Always willing to listen, just not able to take direction.






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New What would cause a bent spark plug tip at the connection? [120-130]
posted by  BoostdRex  on Thu Jul 14 20:25 CST 2011 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.