Volvo RWD 700 Forum

INDEX FOR 1/2026(CURRENT) INDEX FOR 6/2003 700 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE Replies to this message will be emailed.    PRINT   SAVE 

ECT Sensor and Hard Hot Start? 700

posted by  BobbyC on  Fri Aug 2 12:50 CST 2013
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS]
last visit: Tue Oct 29 08:31 CST 2013
[RELATED]

In one place I looked (I think it was the FAQs) it showed a LARGE 2-pin connector (that I've never seen before) that a 3/4" 19mm deep socket would NOT go over, but when I looked up the part on FCP, it showed the sensor has a standard 2-flat-pin Bosch connector (like the fuel injectors have).

If it's the Bosch F/I type, yes, the deep socket should probably fit fine.

Unfortunately, until I get to Phoenix again, I can't see which one my car has. Hopefully, mine is like this picture: http://assets3.fcpstores.com/public/assets/products/40333/product/1346030.jpg?1323097385

Bob







THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New 1 ECT Sensor and Hard Hot Start? [700]
posted by  BobbyC  on Thu Aug 1 15:36 CST 2013 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.