Volvo RWD Forum

INDEX FOR 1/2026(CURRENT) INDEX FOR 6/2001

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE    PRINT   SAVE 

getting main fuel pump line to not leak

posted by  muskox37 on  Wed Oct 2 07:59 CST 2013
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS]
last visit: Wed Oct 8 11:54 CST 2014
[RELATED]

Good morning Tony,

It could be that the pump evolved between 1982 and 1989. My pump, going from rear to front has the pump body, copper washer, the 'jet', copper washer, banjo fitting, copper washer, large 19mm nut.

The 'jet' is about an inch long with threads at either end and a 17mm hexagon 'gripper' in its mid-section. The shorter end threads into the pump body. The longer end [which has four holes perpendicular to each other to allow gas flow] takes the 19mm large nut. This nut crushes the copper washers around the banjo fitting.

Perhaps the pump comes originally with the 'jet' in place.






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New getting main fuel pump line to not leak
posted by  muskox37  on Fri Sep 27 15:43 CST 2013 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.