Volvo RWD 200 Forum

INDEX FOR 10/2025(CURRENT) INDEX FOR 2/2006 200 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE    PRINT   SAVE 

Mechanical Speedo Power Source 200 1985

OK,

So when you are discussing the "foil" you basically mean one of the silver tracks on the circuit board is "slashed" in two? I understand that the board can be removed from the casing with the gauges still attached. Then I assume the next step after that is getting to the other side of the circuit board.

My soldering is fine I do realize however I will need to use a lower wattage iron since I am dealing with much more sensitive material here. When using the wire to bridge, will I actually be using a single strip of wire and connecting?

Thanks Alot






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New 1 Mechanical Speedo Power Source [200][1985]
posted by  xDread92x  on Wed Sep 14 07:19 CST 2016 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.