Volvo RWD 200 Forum

INDEX FOR 10/2025(CURRENT) INDEX FOR 6/2012 200 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE    PRINT   SAVE 

Mechanical Speedo Power Source 200 1985

When you mean ground the wire what are you referring to?

Also, how am I suppose to test the circuit board foils while plugged in? Will I literally take the cluster apart and then attach the connectors to the circuit board alone and test with multi-meter?

Lastly,

I have connected everything back together and both gauges are not working now. The temp sensor wire looks pretty crusty down there but the temp gauge gas always worked. When I placed it back together I put the gauge in, placed the washer down, then the cylindrical copper piece, and then the nut. Is this correct? I still have my speedo disconnected because the previous owner broke the plastic locking piece. I have to figure out how to get that cable re attached but will my speedo being disconnected affect the gauges at all?

Thanks






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New 1 Mechanical Speedo Power Source [200][1985]
posted by  xDread92x  on Wed Sep 14 07:19 CST 2016 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.