Volvo RWD 200 Forum

INDEX FOR 1/2026(CURRENT) INDEX FOR 9/2002 200 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE Replies to this message will be emailed.    PRINT   SAVE 

Ignition lock problem 200 87

posted by  someone claiming to be Gay Smith on  Sun Aug 12 11:54 CST 2001 [RELATED]

I removed and "repaired" the ignition switch today. ( The spring which restores position III to position II had slipped out of it,s seat. )

After I reinstalled the switch, I could not get the key into the lock. There appears to be a tumbler, or piece of metal, right at the key entrance, preventing insertion of the key.

At one point in problem analysis, I gave the lock a shot of WD40. Could this be the source of the problem?

The key was NOT inserted while I removed the switch. It MAY have been there at the outset, but I pulled the key out, after the switch was removed, so I could drive my wife's car.

Any suggestions??





THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New Ignition lock problem [200][87]
posted by  someone claiming to be Gay Smith  on Sun Aug 12 11:54 CST 2001 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.