Volvo RWD 700 Forum

INDEX FOR 1/2026(CURRENT) INDEX FOR 11/2004 700 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE Replies to this message will be emailed.    PRINT   SAVE 

Noisy Driver's Window 700 1992

Hey Don
Just put my new motor /regulator on and it was a piece of cake. Takes less then 40 min. Remove door panel clips on the bottom,speaker cover, door lock button,trim around switches(little button fastener in bottom)side panel insert behind switches. Roll window down about 4", remove plastic well covers. Reach up behind window glass and undo sliding clips off regulator arm pins. Remove plastic washers. Have another person hold window glass and then detach regulator from window. Pull glass out of door, may have to tilt foward and down to remove. Remove outside regulator clip/washer from door. Remove screw from door latch lever and spring. Unscrew the 4 mounting nuts from regulator/motor, unplug electrical connector (grey) and remove.Install was reverse. The new regulator / motor I purchased at OEM Volvo works perfect and the electrical connector was a match. No more wind noise, cold air and tat tat tat sound.
Good Luck
Brad






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New Noisy Driver's Window [700][1992]
posted by  djtibb subscriber  on Tue Jan 22 11:02 CST 2002 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.