Volvo RWD 700 Forum

INDEX FOR 1/2026(CURRENT) INDEX FOR 4/2003 700 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE    PRINT   SAVE 

pulling body panels 700

posted by  Rtilghman on  Wed May 22 13:02 CST 2002
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS] [RELATED]


looking to fix a leak on my 1985 745t and wondering if you can just unbolt and pull the front body panels/fenders by undoung the bolts or if it is welded on.

basically, I think the vent near the driver's left foot may be leaking, but since its mounted to the inside of the wall it seems a waste of time to seal it from the inside; water would still just pull in the crack and seep in over time.

is this possible? I can see that there is the row of bolts under the hood edge, two bolts at the front of the driver's door, and some bolts to hold on plastic underguard and fender pieces around the wheel well.

any advice is appreciated.

thanks,
rt






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New pulling body panels [700]
posted by  Rtilghman  on Wed May 22 13:02 CST 2002 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.