Volvo RWD 700 Forum

INDEX FOR 1/2026(CURRENT) INDEX FOR 3/2003 700 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE Replies to this message will be emailed.    PRINT   SAVE 

Replacement Ball Joints 700

posted by  rene svastal on  Fri Nov 8 10:37 CST 2002
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS]
last visit: Sat Aug 25 14:37 CST 2001
[RELATED]

I may or may not get yelled at for this, but in my experience (granted not too long) Anything stamped with VOLVO or their logo is better than the same product by the same manufacturer without the stamp. This might sound stupid.

Twice I replaced the ball joints, left and right, on my 745 with TRW and they all wore out fast. I do drive very hard but since I've replaced them with VOLVO joints (made by TRW) I haven't worn them out yet.

It's possible that I had a run of bad luck with faulty products, but my mind is made up.

Rene
--
1988 745 GLE B23FT M46 (J-P Type combo). Toronto. 380000Km. Suspension upgraded and lowered . 1982 242 GLT project (B23ET LPT to be included) Also in charge of GF's 1986 244






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New Replacement Ball Joints [700]
posted by  Rtilghman  on Fri Nov 8 09:32 CST 2002 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.