Volvo RWD 700 Forum

INDEX FOR 1/2026(CURRENT) INDEX FOR 12/2007 700 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE    PRINT   SAVE 

Changing just one engine mount 700 1989

posted by  Nmaslan on  Wed Aug 27 13:51 CST 2003
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS]
last visit: Fri Dec 30 18:34 CST 2011
[RELATED]

Hi all,

Update to an earlier post which I posted bout my shifter vibrating. Well I sent my car to the mechanic and had it raised. Tranny mounts ok. Hydraulic mounts right side (near oil filter) was told to be a bit collapsed. Left side still Ok. Not surprised as the right side is exposed to more heat and also from oil from changing the oil filter.

Question - can I just replace one bad hydraulic engine mount? Or is it advisable to do it in pairs? The mechanic advised for me to wait till both engine mounts are shot including the tranny mount. Says it's better to do all 3 at the same time. (Not sure if he's saying that to make my life or his work easier)

Expert advice needed. Thanks






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New Changing just one engine mount [700][1989]
posted by  Nmaslan  on Wed Aug 27 13:51 CST 2003 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.