Volvo RWD 200 Forum

INDEX FOR 1/2026(CURRENT) INDEX FOR 9/2006 200 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE    PRINT   SAVE 

Wew!!! Trailing Arm Bushing is Done. 200

posted by  pageda on  Sat Oct 4 01:11 CST 2003
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS]
last visit: Fri Oct 24 13:18 CST 2014
[RELATED]

I used the 1/2" grade 8 nut and bolt as Neal Wilcer's design calls for and greased them up. Next time I may just collapse the bushings metal housing with a hammer and chisel to see if that is easier and faster than using the tool to remove the old ones. One side at a time would make it a bit easier. Not an easy job but it sure is satisfying when you drive it afterwards.

http://www-ese.fnal.gov/People/wilcer/volvo_trailing_arm_bushing_tool.htm






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New Wew!!! Trailing Arm Bushing is Done. [200]
posted by  yama  on Sat Oct 4 00:48 CST 2003 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.