Volvo RWD 120-130 Forum

INDEX FOR 1/2026(CURRENT) INDEX FOR 3/2005 120-130 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE    PRINT   SAVE 

SU Adjustment Question 120-130

posted by  Tommy on  Fri Nov 28 08:08 CST 2003
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS] [RELATED]

I took apart my SU's (original 1964 HS6's) today to clean them and then put them back together in the car. I went through the adjustment procedure on VClassics and when I got to the part that says:

"3) Raise (or lower) the jets in equal amounts, one flat at a time, until the fastest idle is obtained."

I did this and ran out of adjustment on one carb. I adjusted the jet with the nut until the nut was tight against the spring/body of the carb and it was only at that point that the engine had picked up speed and started to smooth out. I think if I had more adjustment the car would run better. What do I need to do to get more adjustment out of it? Do I need a different jet or can I reposition the needle some?






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New SU Adjustment Question [120-130]
posted by  Tommy  on Fri Nov 28 08:08 CST 2003 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.