Volvo RWD 200 Forum

INDEX FOR 1/2026(CURRENT) INDEX FOR 6/2003 200 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE    PRINT   SAVE 

prepump installation 200 1982

posted by  someone claiming to be Jim on  Tue May 4 04:37 CST 2004 [RELATED]


You should consider opening the cover above the gas tank and check out the condition of the fuel lines, sending unit and wiring prior to doing the actual job. Then you can purchase any additional parts before starting the job.

In particular, try removing the clamps on the fuel lines. I had a bitch of a time with one of mine...When I finally got it off I also discovered that one of the tubes the fuel lines connect to was rusted so I also needed a sending unit - common problem. This is also a good time to determine what clamps you are going to need, the condition of your fuel lines (mine were okay, but my car is a 1990), check wiring etc.

Use some Vaseline on the bung nut when reinstalling, makes it easier.


Jim 90 244DL 235K





THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New prepump installation [200][1982]
posted by  muskox  on Tue May 4 04:07 CST 2004 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.