Volvo RWD 700 Forum

INDEX FOR 1/2026(CURRENT) INDEX FOR 12/2010 700 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE    PRINT   SAVE 

Could the problem be my Clutch Release Fork? 700

posted by  spratz on  Fri Jul 23 03:09 CST 2004
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS] [RELATED]

Awhile ago I posted about my slave cylinder problems and how the piston popped out and leaked the dot3 out of my hydraulic clutch. Well, I put a new seal in this sucker and reinstalled and bled everything but still no clutch. My release fork is backed up all the way to the rear of the trans housing and is pinching the rubber boot. That means the piston in my slave less than an eigth of an inch from exposing the seal again. My question is this: Is it normal for the release fork to travel so far back. And, how can I get it forward again?
Is it trans shop time? Thanks in advance.






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New Could the problem be my Clutch Release Fork? [700]
posted by  spratz  on Fri Jul 23 03:09 CST 2004 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.