Volvo RWD 120-130 Forum

INDEX FOR 1/2026(CURRENT) INDEX FOR 2/2010 120-130 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE    PRINT   SAVE 

washer or not? 120-130

posted by  JohnMc on  Thu Aug 12 02:48 CST 2004
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS]
last visit: Thu Oct 23 07:42 CST 2014
[RELATED]

No, I don't think it touches any moving surface. It just gets held tight between the gear and the cam. The thrust plate goes around it, without touching it. Then the back of the cam gear and the front of the cam big bearing rub against the thrust plate depending on the gear load (as deflected by the angled teeth). The spacer provides the proper gap between the gear and the cam bearing for the thrust plate.
--
I'm JohnMc, and I approved this message.






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New Brass vs. Steel...Cam Retaining Plate [120-130]
posted by  undrtw  on Tue Aug 10 13:14 CST 2004 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.