Volvo RWD 900 Forum

INDEX FOR 1/2026(CURRENT) INDEX FOR 12/2019 900 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE    PRINT   SAVE 

Adjusting misaligned sunroof tracking cable? 900 1991

posted by  ckenney on  Tue Mar 1 05:06 CST 2005
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS]
last visit: Mon Jul 14 06:44 CST 2008
[RELATED]

I hope I am understanding the question

I had/have this same issue with my 960. If you remove the motor, you should be able to manually adjust the cable by sliding the assembly forward or backward. It would appear as though the cog attached to the motor that drives the cable provides tension while the motor is in place. If memory serves the motor is held in place by 2 phillips screws and either a 10 or 11 MM nut. The FAQ might have the correct size. In order to not place too much strain on the wires, i loosened the nut enough to disengage the motor from the cable but not so much that the motor was dangling by the wires.

Good luck and if I may emphasize a point made in the FAQ, do not apply too much pressure on the slide gate when realigning, they tend to break. Good Luck.
--
1993 960 194K






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New Adjusting misaligned sunroof tracking cable? [900][1991]
posted by  parogers  on Tue Mar 1 04:29 CST 2005 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.