Volvo RWD 140-160 Forum

INDEX FOR 1/2026(CURRENT) INDEX FOR 9/2003 140-160 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE    PRINT   SAVE 

Valve float?! Really?! 140-160

Kyle check all your pushrods and make sure they are all straight. I had a stock B20 in my '62 PV and I used to drive it pretty hard. It turns out one of the pushrods was slightly bent and it acted like a "primitive rev limiter" . If I revved it to high it would pop out of the valve adjuster and then of course it would run pretty ragged until I reseated the pushrod. This happened about three or four times before I had a chance to replace the offending pushrod. Good luck with your mini-movie.


Jim






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New Valve float?! Really?! [140-160]
posted by  KLR142  on Thu Apr 14 21:21 CST 2005 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.