Volvo RWD 140-160 Forum

INDEX FOR 1/2026(CURRENT) INDEX FOR 3/2003 140-160 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE Replies to this message will be emailed.    PRINT   SAVE 

B20 block identification 140-160

posted by  Bennie on  Thu Jun 23 07:06 CST 2005
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS]
last visit: Wed Nov 28 03:03 CST 2007
[RELATED]

John,

By far the easiest way to tell is to look at the block like this pic. This specific block is a 6 bolt. The 8-bolt blocks have an extra 'bridge' casted between the walls of cilinder 2 and 3 and the outer side of the block. (hope this makes sense) It's a round bridge basically sitting in between the pushrods of intake/exhaust of both cil. 1 and 2. So in this pic it would be below the coolant hole/passage of cil 1 and 2 (if it would have been an 8-bolt that is)

cheers, ben




--
P131, '65, B20B+M47. P131, '69, B20E+AW71L+LSD. (www.tinustechniek.tk)






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New B20 block identification [140-160]
posted by  jparker3  on Tue Jun 21 06:25 CST 2005 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.