Volvo RWD Forum

INDEX FOR 1/2026(CURRENT) INDEX FOR 1/2004

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE Replies to this message will be emailed.    PRINT   SAVE 

OD Relay Jumper

If I want my OD to be on all the time (I do not tow nor do I drive in hilly areas, thus do not need the OD on/off switch function)can I just leave the jumper on the relay.

Answer assumes you have a 240 series. It wastes time and posts when you omit your car details. Jumper is doable on 700/900 but not as easy.

You'll have to remove the relay and replace it with a jumper wire in the relay harness plug (or relay rack).

Make up a jumper with a 1/4" flat push-on terminal on each end.

Connect the plug socket with the Blue & Gray wires (formerly to relay #15), to the socket with the White wire (formerly relay #87, to solenoid).

The Arrow light should stay off because there will no longer be a ground on the Yellow-Red wire that went to relay #87a and thru the relay to ground.



--
Bruce Young
'93 940-NA (current) — 240s (one V8) — 140s — 122s — since '63.






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New OD Relay Jumper
posted by  yumling  on Tue Jul 12 08:33 CST 2005 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.