Volvo RWD 200 Forum

INDEX FOR 1/2026(CURRENT) INDEX FOR 1/2004 200 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE    PRINT   SAVE 

Engine Code Question 200 1993

Bruce
I think it was in the mode 2 plug, but the # 6 plug also gives a loss of RPM signal. I was not testing the various items in mode 2.
The car began stalling but would restart right away, this happened several times over a couple day period. Finally it didn't start in the driveway, I searched for codes it came up. I had suspected the RPM sensor and felt pretty good when the code came up that I had easily found the problem. Got a new sensor and it has run like a champ ever since. The wires insulation was rotted off near the connector, I assumed they were periodically shorting. Hope this helps. Dan






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New Engine Code Question [200][1993]
posted by  JSBB subscriber  on Sat Jul 16 15:20 CST 2005 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.