Volvo RWD Forum

INDEX FOR 10/2025(CURRENT) INDEX FOR 6/2009

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE    PRINT   SAVE 

1992 245 No start

"One thing I noticed was 2 sets of ground wires (3 grounds) on the front of the fuel rail. I'm not sure I have that."

Yes, those are the grounds Art was talking about and they are quite essential. They should go to pin 20 of the EZK (link), and to pins 5/29 (signal ground) and 17 (power ground) and 19 (code plug or ground) of the ECU (link). Not familiar with "code plug", according to the service manual, pin 19 is also connected to the manifold. LH Jetronic was also used by Porsche and Saab, so perhaps "code plug" might be relevant for them.

The ECU and ICU are only grounded through the wiring loom and not locally to the chassis for noise suppression reasons.






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New 1992 245 No start
posted by  pageda  on Fri Nov 26 13:08 CST 2021 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.