Volvo RWD 200 Forum

INDEX FOR 1/2026(CURRENT) INDEX FOR 8/2003 200 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE    PRINT   SAVE 

Should I replace the head gasket? 200 1988

posted by  Xraybob on  Tue Sep 13 06:26 CST 2011
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS]
last visit: Fri Oct 24 05:32 CST 2014
[RELATED]

I will be installing a "new" engine (1988) sometime in the next few months into my '86 sedan (NA). It has about 150K miles on it now with no known issues in the past. While it's on the engine stand and out of the car, should I go ahead and pull the head and get it inspected and machined if necessary as a preventitive measure? I have someone who can do it for a reasonable price. What else should I have done to the head while it's out if I should go that route?
I will be doing a mini rebuild with all new gaskets and seals, pulling the oil pump, cleaning it and replacing its seals too along with all new sensors, etc.
Thanks in advance.
--
'86 sedan with 462,000 miles on the original engine and automatic transmission






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New Should I replace the head gasket? [200][1988]
posted by  Xraybob  on Tue Sep 13 06:26 CST 2011 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.