Volvo RWD 140-160 Forum

INDEX FOR 1/2026(CURRENT) INDEX FOR 12/2001 140-160 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE    PRINT   SAVE 

How Do I Remove MAP Sensor Screw? 140-160

posted by  Sil on  Mon Sep 12 03:15 CST 2005
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS]
last visit: Fri Oct 24 07:24 CST 2014
[RELATED]

Thanks, Paul. No, I don't have any spares, but I know of a place where I might find a couple, and it's probably not a bad idea to have some in my junk pile. I'm assuming that the MAP sensors used with D-jets of other years were the same, even if the compression on the engines was lower. I'm not running terribly rich, but the plugs are a little darker than they should be. So, I may just back off a bit on the fuel pressure regulator, as Charlie suggested, to see what effect that has, before I go on messing with the MAP sensor.
Bob S.






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New How Do I Remove MAP Sensor Screw? [140-160]
posted by  Sil subscriber  on Sat Sep 10 15:41 CST 2005 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.