Volvo RWD 200 Forum

INDEX FOR 1/2026(CURRENT) INDEX FOR 1/2004 200 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE Replies to this message will be emailed.    PRINT   SAVE 

trailing arm bushing replacement 200 1980

posted by  Erling on  Sat Sep 24 21:24 CST 2005
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS]
last visit: Wed May 22 00:57 CST 2013
[RELATED]

Ah, now I see. And my answer would be no, the tool I made can not be used for pressing in a pre-assembled bushing. The lip would be squeezed between pusher and sleeve. This does not necessarily mean that re-using the old, out-of-the car sleeves is a bad idea, I still have the benefit of removing the old rubber on a workbench rather than under the car. But given the tool I got, I will have to install the empty sleeves first, and then press in the poly bushings. (If installing an empty sleeve is possible, that is. I'm referring to a job planned, not a job done.)

Erling.
--
My 240 Page






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New trailing arm bushing replacement [200][1980]
posted by  sfraser  on Fri Sep 23 10:24 CST 2005 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.