Volvo RWD 200 Forum

INDEX FOR 1/2026(CURRENT) INDEX FOR 4/2012 200 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE Replies to this message will be emailed.    PRINT   SAVE 

Small Clock 200

uid 27's pic
posted by  Art Benstein on  Thu Jul 6 12:59 CST 2006
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS]
last visit: Fri Oct 17 20:10 CST 2014
[RELATED]

Hi Doug,

It is worth doing, if you're comfortable with fiddly bench work:



The trick is to get it open.


Once when I posted this a few years back, Bob Wennerstrom remarked I was doing it the hard way. He said it would be much easier to uncrimp the bezel; that the bit of mangling won't show behind the escutcheon anyway. I tried it, and he is absolutely right.



Try to keep from cutting through, to avoid debris inside the clock mostly.



Use a sturdy knife to finish the cut.



The capacitors are 100 microfarad electrolytic (2) with radial leads. The voltage rating should be at least 16V, but I think you'll find modern units 25V and higher in the same size as the originals. Observe polarity.



Test before you seal it back up.



I used foil tape.



--
Art Benstein near Baltimore

By the time a man is wise enough to watch his step, he's too old to go anywhere.






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New Small Clock [200]
posted by  someone claiming to be Wolfman  on Mon Jul 3 08:57 CST 2006 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.