Volvo RWD 120-130 Forum

INDEX FOR 1/2026(CURRENT) INDEX FOR 9/2012 120-130 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE    PRINT   SAVE 

Conversion Ring, Master Cylinder, Final Setup 120-130

uid 37415's pic
posted by  Old Kombi on  Tue Oct 10 08:56 CST 2006
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS]
last visit: Thu Sep 30 01:42 CST 2010
[RELATED]

Get the old pushrod and add the thickness of the cylinder adaptor to it plus about 1/4 inch. there should be some adjustment on the pedal so you just have to be close. As a rule of thumb I added the thickness of the spacer I made (.5" thick) plus 1/8" (.125") for a pushrod .625" longer than stock, mine is still a little short when fully adjusted out so when the paint dries and I get some time I plan to make a .75 longer pushrod.


Cheers!
Dave G.

PS remember- it is easier to cut or grind some off than it is to add it back on!





THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New Conversion Ring, Master Cylinder, Final Setup [120-130]
posted by  RepairmanJackal subscriber  on Wed Oct 4 15:38 CST 2006 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.