Volvo RWD 120-130 Forum

INDEX FOR 1/2026(CURRENT) INDEX FOR 11/2001 120-130 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE Replies to this message will be emailed.    PRINT   SAVE 

ANSWER replacing ball-joints 120-130

posted by  walrus3 on  Mon Nov 5 06:25 CST 2007
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS]
last visit: Mon Dec 2 14:20 CST 2013
[RELATED]

I would think that 75 ft-lb would be plenty. Are you sure you had the right
nut? Also, the pin of the ball joint should be pretty hard, so the threads
may not be damaged on it. Do you still have the old nut? If it is the same
thread (usually but not always) you could probably use it, if the pin is OK.
--
George Downs, Bartlesville, Heart of the USA!

This post has been marked as an answer to the original question.

THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New ANSWERED replacing ball-joints [120-130]
posted by  undrtw  on Mon Nov 5 06:14 CST 2007 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.