Volvo RWD 444-544 Forum

INDEX FOR 1/2026(CURRENT) INDEX FOR 9/2001 444-544 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE    PRINT   SAVE 

Greasing the PV 444-544

uid 5098's pic
posted by  Sil on  Fri Dec 28 04:39 CST 2007
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS]
last visit: Fri Oct 24 07:24 CST 2014
[RELATED]

Also you might have to use a gun with air pressure.

Paul,
That's what I meant by "pneumatic grease gun", do you have something else in mind? The one I bought is rated for 90 lbs max. So, I didn't dare to take it any higher than 110 lbs. The holes and the passages are clear, I pushed a thin wire into them. Even though I renewed them when I put in the new seals, I had the grease fittings out to make sure they were in good shape. The one thing I didn't do was make sure the little ball valves were movable, like George suggested. I'll try that next.

Bob S.
--
'62 PV544 (B20, M41), '71 142E, '93 240 Classic Wagon.






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New Greasing the PV [444-544]
posted by  Sil subscriber  on Thu Dec 27 10:29 CST 2007 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.