Volvo RWD 200 Forum

INDEX FOR 1/2026(CURRENT) INDEX FOR 9/2015 200 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE    PRINT   SAVE 

Help Testing FPR 200 1983

Well I'm trying to deteremine if the FPR is bad.

I'm following these directions from the FAQ here on brickboard:

"A fairly easy test to see if the FPR is pressuring up too much requires disconnecting the fuel return line (back to the fuel tank) from the rear of the fuel rail. On my 940, this is a simple hose clamp. Be prepared for some fuel to spill. Now get several feet of rubber fuel line hose, slip it over the open end of the fuel rail, and aim it into a gasoline-safe container. Have an assistant start the car, and observe the fuel flow from the hose. You should get a strong stream of fuel, something on the order of 1/2 to 1 gallon per minute. If you get just a trickle or no fuel at all, the FPR is bad. [Tip from Mark Lundell]"

However it looks like a fuel pressure gauge is going to be the best route.






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New Help Testing FPR [200][1983]
posted by  calvinmor  on Tue Sep 21 13:01 CST 2010 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.