Volvo RWD 200 Forum

INDEX FOR 1/2026(CURRENT) INDEX FOR 7/2004 200 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE    PRINT   SAVE 

Am I ready to replace the Crank Position Sensor? 200 1990

posted by  TONY H on  Thu Dec 9 01:37 CST 2010
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS]
last visit: Fri Oct 17 16:39 CST 2014
[RELATED]

A 10mm Swivel Socket makes this job so much easier.

With the '91, the AC dryer is back by the Firewall so it makes this task a bit tougher.
With my '89 I can take a 10mm Box wrench and snake my hand/arm under the exhaust manifold and over to the Bellhousing to crack the Bolt loose and wiggle the sensor out. I'm not sure you can do this with the AC in the way.
--
'75 Jeep CJ5 345Hp ChevyPwrd, two motorcycles, '85 Pickup: The '89 Volvo is the newest vehicle I own. it wasn't Volvos safety , it was Longevity that sold me http://home.lyse.net/brox/TonyPage4.html






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New Am I ready to replace the Crank Position Sensor? [200][1990]
posted by  Euroman  on Mon Dec 6 09:29 CST 2010 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.