Volvo RWD 120-130 Forum

INDEX FOR 1/2026(CURRENT) INDEX FOR 6/2004 120-130 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE    PRINT   SAVE 

ignition switch 120-130 1966

posted by  Budcoldweiser on  Fri Jun 1 11:26 CST 2012
Author: [PROFILE] [EVERY POST] [THREADS] [BEST POSTS] RSS Feed     [IGNORE ALL POSTS]
last visit: Sat Aug 30 15:03 CST 2014
[RELATED]

Hopefully, the key broke leaving the switch in the "on" position. The switch must be in the "on" position to remove the tumbler assembly. The tumbler assembly must be removed to remove the switch from the dash.
It is a bit tricky. On the left hand side (facing the front of the switch) of the switch there is a spring loaded pin which may be pushed in to release the tumbler assembly. The pin is immediately behind the dashboard and must be accessed from behind with a paper clip or piece of wire. Once the pin is depressed, the tumbler and chrome bezel may be withdrawn from the from.
If the switch is still good, you can simply replace the tumbler assembly.
--
1966 122s, 1968 142s, 1969 144s, 1979 245dl, 1989 244gl






THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New ignition switch [120-130][1966]
posted by  volvolvr66  on Fri Jun 1 11:01 CST 2012 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.