Volvo RWD 700 Forum

INDEX FOR 1/2026(CURRENT) INDEX FOR 5/2010 700 INDEX

[<<]  [>>]


 VIEW    REPLY TO THIS MESSAGE Replies to this message will be emailed.    PRINT   SAVE 

Re: Hall Effect Sensor 700 1985

posted by  someone claiming to be John Sargent on  Mon Jul 16 16:59 CST 2001 [RELATED]

The distributor is indexed to the cam and only goes in one way. If you dissamble the distributor re-install the drive dog in the same relative location to the rotor. It can be installed 180 degrees out. The Hall effects do last a long time, but if you are thinking of replacing it I would buy a complete distributor base from IPS in Boise. The new distributor base includes the Hall effect, wiring connector, a new seal and runs about $100 US which is less than $40 more than the Hall effect sensor. Be carful to preserve the wiring connector on the chassis side of the ignition.





THREADED THREADED EXPANDED FLAT PRINT ALL
MESSAGES IN THIS THREAD

New Hall Effect Sensor [700][1985]
posted by  someone claiming to be Bob Hanbury  on Mon Jul 16 12:18 CST 2001 >


<< < > >>



©Jarrod Stenberg 1997-2022. All material except where indicated.


All participants agree to these terms.

Brickboard.com is not affiliated with nor sponsored by AB Volvo, Volvo Car Corporation, Volvo Cars of North America, Inc. or Ford Motor Company. Brickboard.com is a Volvo owner/enthusiast site, similar to a club, and does not intend to pose as an official Volvo site. The official Volvo site can be found here.